Page 1 of 1
Need a barrel drilled for taper pins
Posted: Thu Dec 11, 2014 8:39 pm
by kokopelli
I have an A2 front sight post that was taken off of a new barrel, so it has the taper pin holes already drilled and the pins...I have a new barrel without dimples for the taper pins that I need drilled for them- both are .750...
who can do it?
(I already asked Cranky, he doesn't have the jig...)
Re: Need a barrel drilled for taper pins
Posted: Thu Dec 11, 2014 8:44 pm
by WLJ
You just don't want Cranky juice on it.
Re: Need a barrel drilled for taper pins
Posted: Thu Dec 11, 2014 8:47 pm
by Whootsinator
Can you blame him?
Re: Need a barrel drilled for taper pins
Posted: Thu Dec 11, 2014 8:48 pm
by WLJ
Whootsinator wrote:Can you blame him?
Nope
Re: Need a barrel drilled for taper pins
Posted: Thu Dec 11, 2014 8:59 pm
by kokopelli
At this point I'd tolerate it to get this thing done!
Re: Need a barrel drilled for taper pins
Posted: Fri Dec 12, 2014 12:24 am
by guncrank1
Without a jig to index barrel pin then there is chance to get crooked front sight.
I don't want to buy a 175.00 for a30.00 return.
Re: Need a barrel drilled for taper pins
Posted: Fri Dec 12, 2014 12:28 am
by guncrank1
Best I could do would be use set screws instead if taper pins
Re: Need a barrel drilled for taper pins
Posted: Fri Dec 12, 2014 8:30 am
by Dave1965
guncrank1 wrote:Without a jig to index barrel pin then there is chance to get crooked front sight.
I don't want to buy a 175.00 for a30.00 return.
its an investment in tools, can be written off taxes
Re: Need a barrel drilled for taper pins
Posted: Fri Dec 12, 2014 10:17 am
by guncrank1
Dave1965 wrote:guncrank1 wrote:Without a jig to index barrel pin then there is chance to get crooked front sight.
I don't want to buy a 175.00 for a30.00 return.
its an investment in tools, can be written off taxes
You have to have money to buy it first.
Re: Need a barrel drilled for taper pins
Posted: Fri Dec 12, 2014 10:55 am
by Dustin