Screws or tap??
- richief
- Posts: 669
- Joined: Fri Aug 24, 2012 12:38 pm
- Location: S.E. KY's Apple-Latcha Mts
- Has liked: 2 times
- Been liked: 1 time
- Contact:
Re: Screws or tap??
looks like a tap on the right top. might have to peck the others with a drill to check hardness, or avoid them altogether and find new ground.
-
- KAC Member
- Posts: 6383
- Joined: Sat Mar 03, 2012 8:48 pm
- Location: Metro Louisville
- Has liked: 3 times
- Been liked: 15 times
- Contact:
Re: Screws or tap??
First two holes
Stuck screw
Third hole broken tap
Fourth just a hole
I think the tap is into the chamber??
I was asked to guote
Quoted time and material at standard shop rate too fill in. Three hours
Stuck screw
Third hole broken tap
Fourth just a hole
I think the tap is into the chamber??
I was asked to guote
Quoted time and material at standard shop rate too fill in. Three hours
Last edited by guncrank1 on Sat Oct 04, 2014 11:25 am, edited 1 time in total.
-
- KAC Member
- Posts: 6383
- Joined: Sat Mar 03, 2012 8:48 pm
- Location: Metro Louisville
- Has liked: 3 times
- Been liked: 15 times
- Contact:
Re: Screws or tap??
Do you fill in old scope mount holes?
I have 4 that need filled on a hex receiver Mosin
Should be an easy enough job
Here was question post to me on The Internet.
I have 4 that need filled on a hex receiver Mosin
Should be an easy enough job
Here was question post to me on The Internet.