Page 1 of 1

Crowning a Glock barrel

Posted: Mon Dec 26, 2016 9:22 pm
by guncrank1

Re: Crowning a Glock barrel

Posted: Tue Dec 27, 2016 1:06 am
by Rescue9
Why? I wouldn't expect to see much accuracy in a handgun.

Re: Crowning a Glock barrel

Posted: Tue Dec 27, 2016 12:04 pm
by samb.
Rescue9 wrote:Why? I wouldn't expect to see much accuracy in a handgun.
Maybe a damaged crown and he fixed it?

Re: Crowning a Glock barrel

Posted: Tue Dec 27, 2016 1:10 pm
by guncrank1
samb. wrote:
Rescue9 wrote:Why? I wouldn't expect to see much accuracy in a handgun.
Maybe a damaged crown and he fixed it?
Longer barrel
Cut to factory length

Re: Crowning a Glock barrel

Posted: Tue Dec 27, 2016 1:12 pm
by guncrank1
Rescue9 wrote:Why? I wouldn't expect to see much accuracy in a handgun.

Never had a National Match pistol or seen one in compitetion?

Re: Crowning a Glock barrel

Posted: Thu Dec 29, 2016 12:40 am
by Rescue9
Sorry, no. I didn't think of that though. All my Glocks are for protection and fun.

Re: Crowning a Glock barrel

Posted: Thu Dec 29, 2016 9:01 am
by guncrank1
Rescue9 wrote:Sorry, no. I didn't think of that though. All my Glocks are for protection and fun.
Which means they should shoot 6inch at 25 yards if not better.

Re: Crowning a Glock barrel

Posted: Thu Dec 29, 2016 9:08 am
by PDM
"Only accurate rifles are interesting"
-Col Whelen

Same goes for pistols

Re: Crowning a Glock barrel

Posted: Fri Dec 30, 2016 1:42 am
by richief
Single point in a lathe? 11 degree?

Re: Crowning a Glock barrel

Posted: Fri Dec 30, 2016 3:35 pm
by guncrank1
richief wrote:Single point in a lathe? 11 degree?
Yes lathe turned on my Smithy and the angle is eyeballed.

Re: Crowning a Glock barrel

Posted: Fri Dec 30, 2016 4:29 pm
by RedRocker
I dig it