Kentucky Armory Club
http://kentuckyarmoryclub.com/

Crowning a Glock barrel
http://kentuckyarmoryclub.com/viewtopic.php?f=56&t=21312
Page 1 of 1

Author:  guncrank1 [ Mon Dec 26, 2016 10:22 pm ]
Post subject:  Crowning a Glock barrel

https://youtu.be/1irXxrm5fJs

Author:  Rescue9 [ Tue Dec 27, 2016 2:06 am ]
Post subject:  Re: Crowning a Glock barrel

Why? I wouldn't expect to see much accuracy in a handgun.

Author:  samb. [ Tue Dec 27, 2016 1:04 pm ]
Post subject:  Re: Crowning a Glock barrel

Rescue9 wrote:
Why? I wouldn't expect to see much accuracy in a handgun.


Maybe a damaged crown and he fixed it?

Author:  guncrank1 [ Tue Dec 27, 2016 2:10 pm ]
Post subject:  Re: Crowning a Glock barrel

samb. wrote:
Rescue9 wrote:
Why? I wouldn't expect to see much accuracy in a handgun.


Maybe a damaged crown and he fixed it?

Longer barrel
Cut to factory length

Author:  guncrank1 [ Tue Dec 27, 2016 2:12 pm ]
Post subject:  Re: Crowning a Glock barrel

Rescue9 wrote:
Why? I wouldn't expect to see much accuracy in a handgun.



Never had a National Match pistol or seen one in compitetion?

Author:  Rescue9 [ Thu Dec 29, 2016 1:40 am ]
Post subject:  Re: Crowning a Glock barrel

Sorry, no. I didn't think of that though. All my Glocks are for protection and fun.

Author:  guncrank1 [ Thu Dec 29, 2016 10:01 am ]
Post subject:  Re: Crowning a Glock barrel

Rescue9 wrote:
Sorry, no. I didn't think of that though. All my Glocks are for protection and fun.


Which means they should shoot 6inch at 25 yards if not better.

Author:  PDM [ Thu Dec 29, 2016 10:08 am ]
Post subject:  Re: Crowning a Glock barrel

"Only accurate rifles are interesting"
-Col Whelen

Same goes for pistols

Author:  richief [ Fri Dec 30, 2016 2:42 am ]
Post subject:  Re: Crowning a Glock barrel

Single point in a lathe? 11 degree?

Author:  guncrank1 [ Fri Dec 30, 2016 4:35 pm ]
Post subject:  Re: Crowning a Glock barrel

richief wrote:
Single point in a lathe? 11 degree?


Yes lathe turned on my Smithy and the angle is eyeballed.

Author:  RedRocker [ Fri Dec 30, 2016 5:29 pm ]
Post subject:  Re: Crowning a Glock barrel

I dig it

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/