Big list of items FS with pics
Big list of items FS with pics
First is a CR speed holster that will work with any size Glock 9mm or 40 frame. Fully ajustable for about any shooter. This holster will work with a G26 all the way to a G24 or a G24 with a comp. Take the muzzle cover off and use it with a suppressor. This works because it locks on the trigger guard. $65.00 or trade.
STI sear and disconnector for 1911, Sear is made from S7 and is matched to disconnector. New in package and should be fitted to a hammer. not a drop in set. $30.00
Black powder conversion cylinder and breach face to convert an 1851 navy to shoot .38 S&W cartridge. Also has mounting screws. Has surface rust in a few spots as shown in the pics. $50.00
STI sear and disconnector for 1911, Sear is made from S7 and is matched to disconnector. New in package and should be fitted to a hammer. not a drop in set. $30.00
Black powder conversion cylinder and breach face to convert an 1851 navy to shoot .38 S&W cartridge. Also has mounting screws. Has surface rust in a few spots as shown in the pics. $50.00
Re: Big list of items FS with pics
Adding a Glock factory G18 magazine with a taylor freelance +10 magazine extension this will work as a +8 in .40SW. I was going to get a Keltec sub 2000 but after I shot one left hand It blows powder back in my face so that was a no go. I use the taylor freelance +5 extentions on my .40 mags for limited division and they work great. Machined from solid delrin they will hold up to repeated ground strikes with little or no scratched or dents. I want $75.00 for this mag and extention. The extension new is $50.00 without the magazine. This is an austrian made Glock magazine. First picture shows mag with one of the pre ban mags with plus 2 base next to the 41 shot magazine. Second picture shows Magazine in a G17.
Re: Big list of items FS with pics
Magazine holders that i made to use with the CR speed holster. They hold the mags Bullets facing out from your body and you can pull them straight out or up as normal. They are very fast and they will hold an Ar15 mag too. Hand made from Kydex, delrin, and brass. Set up to work on a 1-1/2" belt. $75.00 for the set. When I was making these I sold them for $150. a set because they were made to order on the angles each person wanted. They can be locked in place on a CR speed belt. Will work for Glock and similar width mags.