anybody into CB's?

Think of the cool gadgets we all love, this would be the place to post about them.
User avatar
kokopelli
KAC Member
KAC Member
Posts: 3611
Joined: Sun Mar 04, 2012 4:14 pm
Has liked: 1 time
Been liked: 17 times

anybody into CB's?

Post by kokopelli » Sun Feb 01, 2015 8:59 pm

I used to be...always had one on the work car and the Jeeps. There used to be a CB shop in Hikes Point and the guy worked on them; I had a small midland that he tuned and peaked. My last car had a Uniden 510xl in it with a magnet mount MaxRad antennae on the center of the trunk that worked pretty good- I got several miles out of it.

I still have the Uniden and want to get it up and running in the Yukon. That one will do me for now- I'm not sure what antennae setup I want to run on it, though. I still have a couple of the MaxRads, so I could use one (or two) of those, plus I have a brand new 102" whip that was going to go on the XJ that died. If I used that, it would go on the end of the bumper...

any ideas?

User avatar
86 slo-vo
KAC Member
KAC Member
Posts: 1862
Joined: Sun Apr 15, 2012 12:56 am
Has liked: 0
Been liked: 0

Re: anybody into CB's?

Post by 86 slo-vo » Sun Feb 01, 2015 9:16 pm

I have always had one in my rigs for talking between vehicles. Never used much more then that.

Did have a nice peaked and tuned cobra in my last rig.
Marcus wrote:KAC, marrying above their league since 2012.

User avatar
Eireguy
Posts: 915
Joined: Sat Mar 10, 2012 12:41 am
Location: Louisville
Has liked: 17 times
Been liked: 1 time

Re: anybody into CB's?

Post by Eireguy » Sun Feb 01, 2015 9:50 pm

The whip is still king if yoy get it grounded right & tuned . Other than that I'd look @ the wilson line of antennas . Like a wilson 1000 or something .
These guys are in Louisville http://www.copper.com/cart/
I have a trc 503 with a trunk mounted wilson 1000 . I need to ground it better but it has saved me from sitting in traffic more than once .

Joe
KAC Member
KAC Member
Posts: 597
Joined: Sun Mar 04, 2012 8:59 am
Has liked: 0
Been liked: 0

Re: anybody into CB's?

Post by Joe » Sun Feb 01, 2015 10:19 pm

K40 if you keep the watts down

Joe
KAC Member
KAC Member
Posts: 597
Joined: Sun Mar 04, 2012 8:59 am
Has liked: 0
Been liked: 0

Re: anybody into CB's?

Post by Joe » Sun Feb 01, 2015 10:20 pm

I ran 102 inch fiberglass whip on my trunk mount for years, Cobra 148 and a Palomar TX300 Last base I ran was a Clemons modified Cobra 2000, Silver Eagle and a Phantom 500. I have my FILs Cobra 142 with an electronic slider and a Palomar 300A. I believe that there is a Palomar TX75 amp around somewhere

User avatar
richief
Posts: 669
Joined: Fri Aug 24, 2012 12:38 pm
Location: S.E. KY's Apple-Latcha Mts
Has liked: 2 times
Been liked: 1 time
Contact:

Re: anybody into CB's?

Post by richief » Sun Feb 01, 2015 10:31 pm

I have an emperor ts-5010 that won't transmit anymore. I wish I knew a place that can trouble shoot to a component level because prob won't get complete assy for what's blown.

User avatar
Jakob
KAC Member
KAC Member
Posts: 836
Joined: Sat Mar 10, 2012 1:53 pm
Location: Louisville, KY
Has liked: 0
Been liked: 0

Re: anybody into CB's?

Post by Jakob » Sun Feb 01, 2015 10:32 pm

Ok, since I found a small hotbed of CB guys... I have an inquiry.

I have a Chrysler 300C that I'd like to have a CB in. I don't want a hard mounted dash unit like what you typically see in pickups. I'd like to have something that I could soft mount (non-permanent mods) to the side of the center console and power it through the cigarette lighter. An antennae on the trunk wouldn't bother me, that could be ran through the cabin and hidden. Is there anything/anyone in the area that knows about or carries something like this? My idea is to keep the power wire, mic, and antennae wire in the center console or next to the drivers seat. Then when I want the CB on, I can holster it in a cradle and plug everything up in a few seconds.
Livewire wrote:I remember when this was a free country and not a fascist one filled with limp wristed, tender hearted, liver lipped bunch of whiny ass cry babies.

User avatar
Eireguy
Posts: 915
Joined: Sat Mar 10, 2012 12:41 am
Location: Louisville
Has liked: 17 times
Been liked: 1 time

Re: anybody into CB's?

Post by Eireguy » Sun Feb 01, 2015 11:17 pm

Well you could velcro it to the side of the console . i use this in my passenger floor well
uploadfromtaptalk1422850485406.jpg
uploadfromtaptalk1422850485406.jpg (6.91 KiB) Viewed 1749 times
. Almost all cbs have external speaker outlets & i have a small one mounted on my dash next to my radar detector . There are all kinds of mounting choices / brackets . Look thru the link i posted above ^ . http://www.copper.com/cart/Radios/CB-Ra ... Hide-a-Way you could also go with something like this all in one .

User avatar
Eireguy
Posts: 915
Joined: Sat Mar 10, 2012 12:41 am
Location: Louisville
Has liked: 17 times
Been liked: 1 time

Re: anybody into CB's?

Post by Eireguy » Sun Feb 01, 2015 11:21 pm

http://www.bellscb.com/ this shop is one of the most respected around . If you want some extra juice or channels or of your radio i would look here for a radio .

guncrank1
KAC Member
KAC Member
Posts: 6387
Joined: Sat Mar 03, 2012 8:48 pm
Location: Metro Louisville
Has liked: 3 times
Been liked: 15 times
Contact:

Re: anybody into CB's?

Post by guncrank1 » Sun Feb 01, 2015 11:25 pm

Radio Shack sold a hand held 40 channel CB years ago, a long shot but Jakob could find one.

User avatar
rustynuts
KAC Member
KAC Member
Posts: 14472
Joined: Sun Feb 10, 2013 8:29 pm
Location: Bardstown
Has liked: 48 times
Been liked: 82 times

Re: anybody into CB's?

Post by rustynuts » Mon Feb 02, 2015 8:58 am

Eireguy wrote:http://www.bellscb.com/ this shop is one of the most respected around . If you want some extra juice or channels or of your radio i would look here for a radio .
When I was driving for a living I picked up a Galaxy radio from Bells and they set me up quite nicely. Glad to see they are still around 20+ years later.

When I bought the GMC I was looking at trucks so I could mount a CB again. With my daily drive they come in handy. I really do need to get one.

User avatar
KYgundude
KAC Member
KAC Member
Posts: 5197
Joined: Sun Mar 04, 2012 7:17 pm
Location: Louisville
Has liked: 97 times
Been liked: 78 times

Re: anybody into CB's?

Post by KYgundude » Mon Feb 02, 2015 1:17 pm

Just so you guys know, Copper Electronics is local. Just off Poplar Level Road.
http://www.copper.com/cart/

User avatar
kokopelli
KAC Member
KAC Member
Posts: 3611
Joined: Sun Mar 04, 2012 4:14 pm
Has liked: 1 time
Been liked: 17 times

Re: anybody into CB's?

Post by kokopelli » Mon Feb 02, 2015 2:10 pm

I had forgotten about Copper...do they do any tune and peak jobs?

User avatar
KYgundude
KAC Member
KAC Member
Posts: 5197
Joined: Sun Mar 04, 2012 7:17 pm
Location: Louisville
Has liked: 97 times
Been liked: 78 times

Re: anybody into CB's?

Post by KYgundude » Mon Feb 02, 2015 2:32 pm

kokopelli wrote:I had forgotten about Copper...do they do any tune and peak jobs?
No clue. I'm a ham and only go there for coax

User avatar
kokopelli
KAC Member
KAC Member
Posts: 3611
Joined: Sun Mar 04, 2012 4:14 pm
Has liked: 1 time
Been liked: 17 times

Re: anybody into CB's?

Post by kokopelli » Mon Feb 02, 2015 9:24 pm

got my cb installed with my Maxrad antenna magnet mount on the roof. I'm not happy with my ground, so that's gotta get changed... doesn't seem to be picking up as much as it should- I'm 1/2 mile from 265 and 64, I should be hearing a LOT of chatter on 19 in sitting in my driveway!
I asked for a radio check today while on 265 at the 64 exit and got a reply, but it was from a driver I could see....

hmmmm....I might just put that 102" whip on the back of the bumper after all.

User avatar
Eireguy
Posts: 915
Joined: Sat Mar 10, 2012 12:41 am
Location: Louisville
Has liked: 17 times
Been liked: 1 time

Re: anybody into CB's?

Post by Eireguy » Mon Feb 02, 2015 10:50 pm

Coppers does tuning & extra channels . I'm not sure about the peak mods .

User avatar
Eireguy
Posts: 915
Joined: Sat Mar 10, 2012 12:41 am
Location: Louisville
Has liked: 17 times
Been liked: 1 time

Re: anybody into CB's?

Post by Eireguy » Mon Feb 02, 2015 11:30 pm

Kokopelli did you tune your antenna ? Yeah I'd say put up that whip if you can . That will get out alot further than a magnet mount .

User avatar
burn360
KAC Member
KAC Member
Posts: 555
Joined: Thu Mar 22, 2012 9:42 pm
Has liked: 0
Been liked: 0

Re: anybody into CB's?

Post by burn360 » Tue Feb 03, 2015 11:15 am

I'm running a Unidien 980SSB and 102" whip I have 1.00 swr on every channel and get great range.
Hard Core Wild Banshee Style!!!!!

User avatar
burn360
KAC Member
KAC Member
Posts: 555
Joined: Thu Mar 22, 2012 9:42 pm
Has liked: 0
Been liked: 0

Re: anybody into CB's?

Post by burn360 » Tue Feb 03, 2015 11:19 am

I'm getting ready to set up my base station still have a few more things to get
Hard Core Wild Banshee Style!!!!!

User avatar
kokopelli
KAC Member
KAC Member
Posts: 3611
Joined: Sun Mar 04, 2012 4:14 pm
Has liked: 1 time
Been liked: 17 times

Re: anybody into CB's?

Post by kokopelli » Tue Feb 03, 2015 3:04 pm

Eireguy wrote:Kokopelli did you tune your antenna ? Yeah I'd say put up that whip if you can . That will get out alot further than a magnet mount .
No- I don't have access to an SWR meter anymore...however, I did put another of my Maxrads on there, and it's a world of difference. The first one had been on the crown-Vic for a few years, and was missing the ball tip. I put this new one on and I am getting a lot better signal; even had to turn the squelch up.
This will work temporarily. As soon as it's warm enough outside to do anything, I'll mount the whip and run my cables under the trim panels...

User avatar
Eireguy
Posts: 915
Joined: Sat Mar 10, 2012 12:41 am
Location: Louisville
Has liked: 17 times
Been liked: 1 time

Re: anybody into CB's?

Post by Eireguy » Wed Feb 04, 2015 3:21 am

You can pick them up @ a Loves or Pilot truck stop . radio shack may still carry them but I'm not sure since its not cell phone related and that seems to be there bread and butter now

User avatar
Eireguy
Posts: 915
Joined: Sat Mar 10, 2012 12:41 am
Location: Louisville
Has liked: 17 times
Been liked: 1 time

Re: anybody into CB's?

Post by Eireguy » Wed Feb 04, 2015 3:22 am

I like ssb radios just not enough room in my little car for one.

User avatar
justang1997
KAC Member
KAC Member
Posts: 3169
Joined: Sun Mar 04, 2012 12:59 pm
Location: Vine Grove
Has liked: 0
Been liked: 0

Re: anybody into CB's?

Post by justang1997 » Tue Feb 10, 2015 12:19 pm

Jakob wrote:Ok, since I found a small hotbed of CB guys... I have an inquiry.

I have a Chrysler 300C that I'd like to have a CB in. I don't want a hard mounted dash unit like what you typically see in pickups. I'd like to have something that I could soft mount (non-permanent mods) to the side of the center console and power it through the cigarette lighter. An antennae on the trunk wouldn't bother me, that could be ran through the cabin and hidden. Is there anything/anyone in the area that knows about or carries something like this? My idea is to keep the power wire, mic, and antennae wire in the center console or next to the drivers seat. Then when I want the CB on, I can holster it in a cradle and plug everything up in a few seconds.
Cobra wx 75. The whole radio is contained in the handmike portion. Gave mine to a buddy who uses it in his Miata.
I have a bearcat 980ssb also. Run I with either a 102 whip on the bumper or a 4 foot firestick. Cobra hand held in the cargo box.
Image

Return to “Other guy stuff”

×