Kentucky Armory Club

Posted: **Sun Jan 21, 2018 7:22 pm**

Ive always wanted a Hunter X22 stock, but they're not made to accommodate a Tac Sol SB-X barrel. Today that changed. I picked up a used stock, a Dremel, and some 80 & 100 grit sandpaper.

Before:

Posted: **Sun Jan 21, 2018 7:24 pm**

After

Sent from my iPhone using Tapatalk

Posted: **Sun Jan 21, 2018 9:23 pm**

Nice. I’m assuming the barrel is still floated.

Posted: **Mon Jan 22, 2018 8:54 am**

Livewire wrote:Nice. I’m assuming the barrel is still floated.

Actually no. The original design of the X22 stock has a rib on the muzzle end of the barrel tray that the barrel rests on. I had to cut out that area of the barrel tray to allow room for the silencer shroud. Now, the shroud itself rests slightly on the end of the stock. I'm torn whether to leave it as is, retrofit another "rib" near the end of the barrel tray, or sand some more where the shroud makes contact with the stock and make it a true "free float"

Posted: **Mon Jan 22, 2018 5:59 pm**

Livewire wrote:Nice. I’m assuming the barrel is still floated.

It is now. Cant wait to dial it in.

Posted: **Thu Feb 01, 2018 5:33 pm**

Sent from my iPhone using Tapatalk

Kentucky Armory Club

Magpul Hunter X22 modification

Magpul Hunter X22 modification

Re: Magpul Hunter X22 modification

Re: Magpul Hunter X22 modification

Re: Magpul Hunter X22 modification

Re: Magpul Hunter X22 modification

Re: Magpul Hunter X22 modification