Was asked to install one of these on a BT-99 stock at a LOP 13.5 inch.
Had to cut two inch off of stock.
Plus there is a custom adjustable cheek piece to be installed
Kind of like this
Too much not enough room
More picture later but not of Dolly
Too much Gracoil not enough stock
-
guncrank1
- KAC Member
- Posts: 6383
- Joined: Sat Mar 03, 2012 8:48 pm
- Location: Metro Louisville
- Has liked: 3 times
- Been liked: 15 times
- Contact:
Too much Gracoil not enough stock
http://www.graco-corp.com/t/gracoil
Was asked to install one of these on a BT-99 stock at a LOP 13.5 inch.
Had to cut two inch off of stock.
Plus there is a custom adjustable cheek piece to be installed
Kind of like this
Too much not enough room
More picture later but not of Dolly
Was asked to install one of these on a BT-99 stock at a LOP 13.5 inch.
Had to cut two inch off of stock.
Plus there is a custom adjustable cheek piece to be installed
Kind of like this
Too much not enough room
More picture later but not of Dolly
-
ChopperDoc
- KAC Member
- Posts: 5778
- Joined: Tue Mar 06, 2012 4:14 pm
- Has liked: 0
- Been liked: 1 time
Re: Too much Gracoil not enough stock
"You rarely rise to the occasion, you usually just sink to your lowest level of training."
-
guncrank1
- KAC Member
- Posts: 6383
- Joined: Sat Mar 03, 2012 8:48 pm
- Location: Metro Louisville
- Has liked: 3 times
- Been liked: 15 times
- Contact:
Re: Too much Gracoil not enough stock
etownguy wrote:my dads Kreighoff has something similar to this they are quite effective
Yes it is a little hydraulic cylinder.
