JHPs
-
KYgundude
- KAC Member
- Posts: 5096
- Joined: Sun Mar 04, 2012 7:17 pm
- Location: Louisville
- Has liked: 93 times
- Been liked: 76 times
JHPs
I typically cycle a couple boxes of JHPs through a weapon to make sure it can feed them reliably before I will trust them for self defense. What's people's thoughts on wheel guns? I'm going to keep my GP100 loaded with JHPs. I'm thinking I will fire one cylinder of the stuff and says, "Yeah, the firing pin works on these". Thoughts?
-
irishrob
- KAC Member
- Posts: 2323
- Joined: Sun Jan 20, 2013 1:17 am
- Location: Louisville
- Has liked: 74 times
- Been liked: 62 times
Re: JHPs
Never had an issue with a revolver. From JHP to wad cutters that were seated flush with case. Only problem I’ve ever heard was if the timing was off a little on the cylinder rotation & that’s extremely rare.
-
PDM
- KAC Member
- Posts: 5809
- Joined: Thu Oct 30, 2014 5:17 pm
- Location: Bardstown
- Has liked: 89 times
- Been liked: 47 times
Re: JHPs
Only thing with wheel guns is making sure hammer spring is not getting weak
"The unlimited power of the sword is not in the hands of either the federal or the state governments, but, where I trust in God it will ever remain, in the hands of the people."
Tench Coxe
Tench Coxe
-
KYgundude
- KAC Member
- Posts: 5096
- Joined: Sun Mar 04, 2012 7:17 pm
- Location: Louisville
- Has liked: 93 times
- Been liked: 76 times
Re: JHPs
They were a blast to shoot. Some 158gr CCI JHPs I got off Niceguy. Flew through a couple of cylinders in the GP and they make remarkable fireballs. Hotter than my ball ammo. I like having a DA Revolver handy for middle of the night type home defense. It's hard to fuck up firing one. I previously ran 38 Wadcutters to prevent it from going through walls but after much research, when brick is not involved, I've concluded the wads are punching right through just like the JHPs do, so might as well have the big boy rounds in her.