Rem R1 enh thrd bbl on a Kimber Warrior... Would it Work OK?

Post by **adayton** » Wed Aug 26, 2015 1:05 pm

I was thinking to myself.while cleaning my R1 this morning (after a range session yesterday....It fits and cycles manually without an issue... I'm just wondering if there is something that would be unsafe....for.some unknown reason....so I thought I would run it by all of you for.your comments, suggestions, etc.....I would think this would be nearly the same as ordering a generic 1911 threaded barrel and assembling the Kimber with it.....
Thoughts, comments, suggestions?
Thanx, Allan

Post by **guncrank1** » Wed Aug 26, 2015 1:57 pm

Post by **adayton** » Fri Aug 28, 2015 11:15 am

guncrank1 wrote:Yes

Haha ... I love your short (and to the point) answers, Cranky ... but sometimes it confuses me ...
Are you saying 'yes', it would be unsafe .... or 'yes', it would work just fine ... ?
Thanx,
Allan

Post by **guncrank1** » Fri Aug 28, 2015 11:28 am

adayton wrote:[quote.
Are you saying 'yes', .... or 'yes', it would work just fine ... ?
Thanx,
Allan

Yes

Post by **adayton** » Fri Aug 28, 2015 11:32 am

guncrank1 wrote:
adayton wrote:[quote.
Are you saying 'yes', .... or 'yes', it would work just fine ... ?
Thanx,
Allan
Yes

Alright ... Gotcha ... I am a little slow sometimes.
Thanx

Post by **kyswede** » Fri Aug 28, 2015 1:05 pm

Gotta love a one word answer to multiple questions.
:llama:

Kentucky Armory Club