Collapsible stock on a milled Aresenal

Post by **dbh** » Sat Sep 01, 2012 3:20 pm

I want to put a collapsible stock on my Arsenal that has a milled receiver (the fixed one that came on it is just too short for my monkey arms). Everything that I have found requires you to cut off the lower tang. Any suggestions?

TIA

Post by **DDgunslinger** » Sat Sep 01, 2012 3:25 pm

Yea, your not left with much options there. I'm putting an ACE folding stock on my AMD. I'm just gonna order the stock and take it to cranky to have it install.

Post by **dbh** » Sat Sep 01, 2012 3:59 pm

You going to have him cut off tangs ?

Post by **DDgunslinger** » Sat Sep 01, 2012 4:28 pm

dbh wrote:You going to have him cut off tangs ?

Well there are two different models of the ACE, but the one I'm getting actually envolved alittle bit more work to the receiver.. But yes there will be some cutting involved.

Post by **Geno** » Sat Sep 01, 2012 5:16 pm

A milled AK with a collapsible stock is like a double quarter pounder, large fries, and fried apple pie...with a diet coke! :llama:

Just kidding! I have a turkey neck with monkey arms. I found a slip on recoil pad that fit well enough to add some length. Good luck. Geno

Post by **nemo** » Sat Sep 01, 2012 5:23 pm

I have a side folding conversion if you are interested. No mods needed, just remove old stock and install new.

Kentucky Armory Club